Marlin 2.1.1 Error

[jimmysdiy]

I have enabled #define ARC_Support in Marlin 2.1.1. However, the Arc-Welder plugin indicates the following error in OctoPrint.
Your firmware may have issues running gcode produced by Arc Welder. You may need to alter firmware settings or upgrade to a newer version.

Last Check On:08/30/22 10:32:36
Name:Marlin
Version:2.1.1
Supported:Yes
Arcs Supported:Yes
3D-Arcs Supported:Yes
Arcs Enabled:Yes
Newer Version:This firmware is newer than the most recent version in the Firmware Library. Some info may be outdated.
Errors:
Your firmware requires the 'G90/G91 Influences Extruder' setting to be ENABLED. Edit the Ocotprint feature setting 'G90/G91 overrides relative extruder mode', set the value to ENABLED, and run the firmware check again.

This never occurred with 2.0.9.3. I had same enablements.

[jimmysdiy]

Just wanted to add - Formerly, i had Arc Welder 1.0 and now I have the RC4